Virtual Server with 443 (HTTPS)
rodrigosh
Member ✭
Dear, I am new to A10 and I need to create a virtual server with a service group and its real servers in 443. When I finish the configuration and test the site in the browser, it gives me the following:
bad request
Your browser sent a request that this server could not understand.
Reason: You're speaking plain HTTP to an SSL-enabled server port.
Instead use the HTTPS scheme to access this URL, please.
0
Comments
This sounds like your web server on the back end is expecting a SSL connection from the A10. When you configure a Layer 7 virtual port such as "port 443 https", the A10 will act as a full HTTP proxy. A client-ssl template is needed between the client and the A10, and a server-ssl template is needed if SSL is required between A10 and the back end server. Do you have both of these configured? Perhaps you can share a redacted VIP config.
Does the GUI configuration work for you or do you need the CLI configuration? As I said before, I am new to A10 and I am not comfortable with the commands they have.
Sure - in the gui, navigate to ADC > SLB and open your VIP. Edit the 443 vPort on the right. Here you will see your client / server SSL template configuration. You can also create these templates from this screen by clicking the "Add+" button on the right side.
From CLI, you can run the command "show run slb virtual-server" which will display all your VIP config.