Measure the attenuation and transmission power
dlima
Member ✭
Gentlemen,
I have a A10 TH930 in my infra and I'd love to know if is possible to measure the transmission and attenuation power (dB) of my optical system.
Are there some specific command in A10 Cisco like:
# show controllers [interface] phy
...
Thresholds:
...
Temperature: 28.484
Voltage: 3.317 Volt
Tx Bias: 3.630 mAmps
Tx Power: 0.19660 mW (-7.06416 dBm)
Rx Power: 0.01120 mW (-19.50782 dBm)
...
I have a A10 TH930 in my infra and I'd love to know if is possible to measure the transmission and attenuation power (dB) of my optical system.
Are there some specific command in A10 Cisco like:
# show controllers [interface] phy
...
Thresholds:
...
Temperature: 28.484
Voltage: 3.317 Volt
Tx Bias: 3.630 mAmps
Tx Power: 0.19660 mW (-7.06416 dBm)
Rx Power: 0.01120 mW (-19.50782 dBm)
...
0
Comments
I do not think we have this option. I verified in 4.x and 2.7 builds and I do not see the option. Is there a specific reason why you need this command? Let me know how we can help.
Genard
Measure those parametres are key to know if the are some problems with the fiber optics. And second, you don't need to send two technicians in site A and B to do the measurement, with the advantage that you don't need to stop the link.
The best would be to open a feature request with your SE.
Anyway guys, thanks for the help!
Att.
Daniel