Hi Experts,
I have a TH3030S device which always in fully 100% CPU performance.
Now I want to set Controll CPU is upto 2 cores and Data CPU is 6 cores.
What do I can do via CLI or GUI.
Best regards!
The following command will accomplish this. A reboot is required for the change to take effect.
TH3030S(config)#multi-ctrl-cpu 2
Is the high CPU usage expected due to particular management traffic, health checks, or similar?
Hi mdunn,
I also know about command "multi-ctrl-cpu" but look like it is not effectitve in mode config:
ACOS(config)#multi-ctrl-cpu 2
^
% Unrecognized command.Invalid input detected at '^' marker.
Or I have some mistake anywhere?
Looking for your help again!
That is definitely the correct command, so that is very strange... Are you using the local admin account on the device? What version of ACOS are you running?
Yes of course I am using the default account local admin on the deivce. My version of ACOS is 4.1.4-GR1-P9
Comments
The following command will accomplish this. A reboot is required for the change to take effect.
Is the high CPU usage expected due to particular management traffic, health checks, or similar?
Hi mdunn,
I also know about command "multi-ctrl-cpu" but look like it is not effectitve in mode config:
ACOS(config)#multi-ctrl-cpu 2
^
% Unrecognized command.Invalid input detected at '^' marker.
Or I have some mistake anywhere?
Looking for your help again!
That is definitely the correct command, so that is very strange... Are you using the local admin account on the device? What version of ACOS are you running?
Yes of course I am using the default account local admin on the deivce. My version of ACOS is 4.1.4-GR1-P9