-
GSLB
I am trying to implement a GSLB deployment with two data centers geographically located in different locations.\ How is the DNS configuration managed so that requests that reach the External DNS are taken to the A10 for resolution? Has anyone already done this type of deployment before? This is the topology I'm trying to…
-
GSLB Gateway transparent Health monitor validation
Hello How can I configure the A10 to validate the GSLB gateway using a Health check with transparent to 8.8.8.8? for example, like we do in slb server because by default GSLB gateway validation is an ICMP to the gateway IP but if the gateway is UP but does not have access to the Internet the A10 will not know so it will…
-
DNS Response as Authoritative from GSLB server mode A10
Hi I want to configure the a10 to response as Authoritative so when someones quieres a FQDN in the A10 as server mode they will get the Authority flag = 1 I attach some screenshoots from my lab As you can see in the second screenshot authority = 0 Thanks for the help!
-
GSLB ZONE AS A RECORD
Hello! I´m configuring GSLB with a challenge which is to answer the queries for example.com as A record. example.com -> x.x.x.x The thing is that when we configured GSLB we have to add the domain in the zone and then configure the services for example www.example.com Does someone know how can I do this?
-
Question - GSLB Initial Configuration
Hello all, I’m just a bit confused when it comes to configuring my new A10 vThunder ADC/SLB with GSLB. I have been attempting to configure it per A10’s documentation, Would someone be willing to explain it a bit more for how its done in the GUI? I have 4 vThunders (2 per data center) and so far has 1 partition not…
-
I have some doubts about the A10 GSLB configuration,
Good day,dear all. We encountered some difficulties in configuring GSLB.Some configurations are as follows: gslb zone sgss.com.cn policy policy-test service 80 www policy policy-test dns-a-record www-ctc static admin-ip 100 dns-a-record www-ctcv6 static admin-ip 100 dns-a-record www-cuc static admin-ip 100 service 80 sso…
-
nslookup shown request timed-out
Hi Friends, I've been recently deployed GSLB setup in both DC & DR and dns delegation is working fine with the health checks. But when I try to trace the sites which I'm hosting it will show time-out waiting response. Any thoughts what cause this?
-
Need help to config DNS static entry on GSLB.
From the ADC datasheet ACOS ADC support DNS RPZ (response policy zone). We have a10 thunder boxes acting as GSLB controller/device and would like to move few thousands static dns entries from the old dns server to A10. For now each static entry is a GSLB service-ip with health-check disable, attach to a site name PRIVATE…
-
Health check did not work in GSLB
I have three ISP line,ISP1,ISP2 and ISP3. We check the ISP's health status with ICMP protocol,when ISP1 down,how to know the status?When ISP1 down,If the health check monitor go out through ISP2 or ISP3?So A10 can't know the ISP1 down.The health check monitor did not work.
-
How can I configure GSLB active/active for 2 sites ?
Hi All, I'm a newbie with A10 product. I'm facing with problem is: I have 2 sites was configured in GSLB and there are in GSLB Group for GSLB controler redundancy. Now, only one site have primary controller response for DNS and another is not response. In this situation, I want to both sites will response for DNS request…
