Hello,
is it possible to active “ve-stats enabled” in a VCS, so that is saved in the startup and running config? I tried it, but got this message in the logfile. Ve stats are counted on the vcs master, but not on the vcs blade. Vcs master and vrrp-a active are the same system at the moment.
-------------------------------------
Active(config)\#show version | inc version
64-bit Advanced Core OS (ACOS) version 2.6.1-GR1, build 107 (Feb-27-2012,17:58)
-------------------------------------
Active(config)\#ve-stats enable
Active(config)\#sh log
May 02 2012 11:15:37 Error [VCS]:Failed to save or get device specific configuration to configuration database. VCS: Invalid parameter
May 02 2012 11:15:37 Error [VCS]:The message is not supported. Module: 41217 Type: 7 Sub-type: 86
---------------------------------
VirtualEthernet 3524 is up, line protocol is up
Hardware is VirtualEthernet, Address is 001f.a002.b578
Router Interface for L2 Vlan 3524
173880 packets input 42046784 bytes
Received 11885 broadcasts, Received 26198 multicasts, Received 135797 unicasts
144748 packets output 28654209 bytes
Transmitted 7577 broadcasts, Transmitted 26149 multicasts, Transmitted 111022 unicasts
-----------------------------------
Active(config)\#show startup-config | include ve-sta
Active(config)\#show run | include ve-st
-----------------------------------
Kind regards
Klaus