HI All, I'm sure theres an easy way to do this and I'm totally missing it. I'm trying to shutdown a ve interface on a vblade, the interface on the vmaster has already been disabled, but I get the message "This device is currently a vBlade. Try using the virtual chassis floating IP address instead." I've logged into the…
We have a pair of thunder 3040 used for CGNAT in vChassis mode. We need to split it in two Standalone nodes. We will do it using the command: "vcs disable" A colleague mentioned that no disruption will occur. But I would like to double-check it. I looked into "ACOS 4.1.4-GR1-P5 Configuring ACOS Virtual Chassis Systems"…
Hi, My company has two AX 2500 (2.7.1-GR1) forming an aVCS cluster. The boxes are in the same building right now and we want to move one box to another DC. Both sites are connected via L2 service and latency is low. The interface election protocol runs on the management interface for aVCS. We want to keep the benefits of…
Getting a bunch of these in the logs: vMaster is inconsistent with vBlade 0 Here is what I am seeing in the various vcs show commands: A10-1-Active-vMaster[1/1]#sh vcs summ VCS Chassis: VCS Enabled: Yes Chassis ID: 1 Floating IP: 10.1.99.100 Mask: 255.255.255.0 Multicast IP: 224.0.0.210 Multicast Port: 41217 Version:…
Hi all, I have a pair of 3030s running 4.01 that I am setting up in an aVCS VRRP-a pair that will replace a couple of Cisco CSS devices. One question I do have is on the CSS pair I track an upstream external router with an ICMP ping to check if it is 'Alive' if it fails to respond then it forces a failover in the pair so…
hello community i am very new to A10 and to this community. so please bear with me. we are currently in the process of preparing a poc with A10 ADCs and i have a question related to the setup and especially to HA and aVCS. due to specific requirements from the customer we will implement two AX1030 in a HA deployment. now…
