Hi community
I’m new in a10 knowledge and I want to ask your help with a doubt
I can’t reach a real server, when I apply a test and a debug I can see that no traffic is sending to that server IP. That server is not in the same LAN segment I can ping that server and reach it through my default gw that is a Checkpoint FW
I see the FW IP in my arp table I not see the IP of the server because is not in my arp table, I only can reach that server IP through de FW (My def gw)
This is my configuration for that service:
vlan 313 untagged ethernet 3 router-interface ve 313 ! vlan-global enable-def-vlan-l2-forwarding ! hostname MITMTY-A10-01 ! interface ethernet 3 enable ! interface ve 313 ip address 172.16.10.198 255.255.255.0 ! ip nat pool SNAT_172_16_10_0 172.16.10.197 172.16.10.197 netmask /24 ! ip route 0.0.0.0 /0 172.16.10.254 ! slb server WAF_SRV_MITEC 172.16.60.210 >>>>as you can see the server is in other segment health-check-disable port 40020 tcp health-check-disable ! slb service-group WAF_EPAGO tcp member WAF_SRV_MITEC 40020 ! slb virtual-server ADC_WAF_E-PAGO 172.16.10.100 extended-stats port 80 http extended-stats source-nat pool SNAT_172_16_10_0 source-nat auto service-group WAF_EPAGO use-rcv-hop-for-resp
Can you tell me if there is something lacking in my configuration The trace rach the server through the FW I send a Telnet to the server IP in the 40020 port and the connection is successful
Your help will be great for me
Thanks.