Command "trunk-group (id group) lacp" is not enable in partition

Product Discussions ADC - Application Delivery
,
1

Hi experts,
I have a trouble when i config in CLI the command “trunk-group” (ex: trunk-group 1 lacp) on Thunder 1030S device.
It still actives in part shared, but not actives in part LV3.
My configuraion is below:
Netpo_Thunder_1030S#conf t
Netpo_Thunder_1030S(config)#active-pa
Netpo_Thunder_1030S(config)#active-partition par1
Current active partition: par1
Netpo_Thunder_1030Spar1interface ethernet 1
Netpo_Thunder_1030Spar1#trunk-group 1 lacp
                        ^
% Unrecognized command.Invalid input detected at ‘^’ marker.
I got it that the command “trunk-group” is not enable in partition except part shared, that’s right?
How can i fix it?
Best regards for all advice!

2

Hi Alden,
You are correct that the trunk-group config is handled in shared. Within the L3V partition, you can specify the tagged interface as the trunk without any additional config in the L3V. Here’s a simplified example. Hopefully this works for you:

active-partition shared
interface ethernet 1 
  enable 
  trunk-group 1 lacp 
    timeout short 
!
interface ethernet 2 
  enable
  trunk-group 1 lacp 
    timeout short 
!
!
active-partition L3V
!
vlan 10 
  tagged trunk 1
  router-interface ve 10 
!
vlan 11 
  tagged trunk 1
  router-interface ve 11
!
vlan 12 
  tagged trunk 1
  router-interface ve 12 
3

Hi mdunn,
Thanks for your advice. I also have a case with A10 support about that problem and the experts give me information same with you. My work are cleared.
Thank you again!